United States International Trade Commision Rulings And Harmonized Tariff Schedule
faqs.org  Rulings By Number  Rulings By Category  Tariff Numbers
faqs.org > Rulings and Tariffs Home > Rulings By Number > 2004 NY Rulings > NY K86973 - NY K87034 > NY K86988

Previous Ruling Next Ruling
NY K86988




July 15, 2004

CLA-2-17:RR:NC:SP:232 K86988

CATEGORY: CLASSIFICATION

TARIFF NO.: 1806.20.9900

Mr. Robert V. Tinkham
Chicago Sweeteners Incorporated
1700 Higgins Road
Suite 610
Des Plaines, Illinois 60018

RE: The tariff classification and status under the North American Free Trade Agreement (NAFTA), of compound coatings from Canada; Article 509

Dear Mr. Tinkham:

In your letter dated June 21, 2004 you requested a ruling on the status of compound coatings from Canada under the NAFTA. Your request also asks for the country of origin for marking purposes.

The subject merchandise is stated to contain 56 percent to 63 percent sugar, 26 percent to 34 percent palm kernel or other vegetable oil, 3 percent to 7 percent cocoa powder (10 percent to 12 percent fat), 3 percent to 8 percent skim milk powder and/or whey powder, and traces of vanillin, lecithin, emulsifiers, salt and flavorings. The sugar will be refined in Canada from raw sugar produced in non-NAFTA countries. The palm kernel or other vegetable oil will be from non-NAFTA countries. The cocoa powder will be manufactured in the United States from non-NAFTA cocoa beans. The skim milk powder and whey powder will be produced in the United States. The other ingredients will be from the United States or from non-NAFTA countries. The compound coatings will be produced in Canada and shipped to the United States in bulk liquid tankers. The merchandise will be used as coatings for bakery products, confections and ice cream.

The applicable subheading for the compound coatings will be 1806.20.9900, Harmonized Tariff Schedule of the United States (HTS), which provides for chocolate and other food preparations containing cocoa...other preparations...in liquid, paste, powder, granular or other bulk form in containers or immediate packings, of a content exceeding 2 kg...other...other...other. The general rate of duty will be 8.5 percent ad valorem.

General Note 12(b), HTSUS, sets forth the criteria for determining whether a good is originating under the NAFTA. General Note 12(b), HTSUS, (19 U.S.C. § 1202) states, in pertinent part, that

For the purposes of this note, goods imported into the customs territory of the United States are eligible for the tariff treatment and quantitative limitations set forth in the tariff schedule as "goods originating in the territory of a NAFTA party" only if--

(i) they are goods wholly obtained or produced entirely in the territory of Canada, Mexico and/or the United States; or

(ii) they have been transformed in the territory of Canada, Mexico and/or the United States so that--

(A) except as provided in subdivision (f) of this note, each of the non-originating materials used in the production of such goods undergoes a change in tariff classification described in subdivisions (r), (s) and (t) of this note or the rules set forth therein, or

(B) the goods otherwise satisfy the applicable requirements of subdivisions (r), (s) and (t) where no change in tariff classification is required, and the goods satisfy all other requirements of this note; or

(iii) they are goods produced entirely in the territory of Canada, Mexico and/or the United States exclusively from originating materials; or

(iv) they are produced entirely in the territory of Canada, Mexico and/or the United States but one or more of the nonoriginating materials falling under provisions for "parts" and used in the production of such goods does not undergo a change in tariff classification because--

(A) the goods were imported into the territory of Canada, Mexico and/or the United States in unassembled or disassembled form but were classified as assembled goods pursuant to general rule of interpretation 2(a), or

(B) the tariff headings for such goods provide for and specifically describe both the goods themselves and their parts and is not further divided into subheadings, or the subheadings for such goods provide for and specifically describe both the goods themselves and their parts,
provided that such goods do not fall under chapters 61 through 63, inclusive, of the tariff schedule, and provided further that the regional value content of such goods, determined in accordance with subdivision (c) of this note, is not less than 60 percent where the transaction value method is used, or is not less than 50 percent where the net cost method is used, and such goods satisfy all other applicable provisions of this note.

Based on the facts provided, the compound coatings described above qualify for NAFTA preferential treatment, because it will meet the requirements of HTSUSA General Note 12(b)(ii)(A). The goods will therefore be entitled to a free rate of duty under the NAFTA upon compliance with all applicable laws, regulations, and agreements.

Your inquiry also requests a ruling on the country of origin marking requirements for imported articles which are processed in a NAFTA country prior to being imported into the U.S. A marked sample was not submitted with your letter for review.

The marking statute, section 304, Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that, unless excepted, every article of foreign origin (or its container) imported into the U.S. shall be marked in a conspicuous place as legibly, indelibly and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate the ultimate purchaser in the U.S. the English name of the country of origin of the article. Part 134, Customs Regulations (19 CFR Part 134) implements the country of origin marking requirements and exceptions of 19 U.S.C. 1304.

The country of origin marking requirements for a "good of a NAFTA country" are also determined in accordance with Annex 311 of the North American Free Trade Agreement ("NAFTA"), as implemented by section 207 of the North American Free Trade Agreement Implementation Act (Pub. L. 103-182, 107 Stat 2057) (December 8, 1993) and the appropriate Customs Regulations. The Marking Rules used for determining whether a good is a good of a NAFTA country are contained in Part 102, Customs Regulations. The marking requirements of these goods are set forth in Part 134, Customs Regulations.

Section 134.1(b) of the regulations, defines "country of origin" as the country of manufacture, production, or growth of any article of foreign origin entering the U.S. Further work or material added to an article in another country must effect a substantial transformation in order to render such other country the "country of origin within this part; however, for a good of a NAFTA country, the NAFTA Marking Rules will determine the country of origin. (Emphasis added).

Section 134.1(j) of the regulations, provides that the "NAFTA Marking Rules" are the rules promulgated for purposes of determining whether a good is a good of a NAFTA country. Section 134.1(g) of the regulations, defines a "good of a NAFTA country" as an article for which the country of origin is Canada, Mexico or the United States as determined under the NAFTA Marking Rules. Section 134.45(a)(2) of the regulations, provides that a "good of a NAFTA country" may be marked with the name of the country of origin in English, French or Spanish.

You state that the imported compound coatings are processed in a NAFTA country "Canada" prior to being imported into the U.S. Since, "Canada" is defined under 19 CFR 134.1(g), as a NAFTA country, we must first apply the NAFTA Marking Rules in order to determine whether the imported compound coatings are goods of a NAFTA country, and thus subject to the NAFTA marking requirements.

Part 102 of the regulations, sets forth the "NAFTA Marking Rules" for purposes of determining whether a good is a good of a NAFTA country for marking purposes. Section 102.11 of the regulations, sets forth the required hierarchy for determining country of origin for marking purposes. Applying the NAFTA Marking Rules set forth in Part 102 of the regulations to the facts of this case, we find that the imported compound coatings are goods of “Canada”, for marking purposes, noting the requirements of Section 102.20(d).

This ruling is being issued under the provisions of Part 181 of the Customs Regulations (19 C.F.R. 181).

A copy of the ruling or the control number indicated above should be provided with the entry documents filed at the time this merchandise is imported. If you have any questions regarding the ruling, contact National Import Specialist John Maria at 646-733-3031.

Should you wish to request an administrative review of this ruling, submit a copy of this ruling and all relevant facts and arguments within 30 days of the date of this letter, to the Director, Commercial Rulings Division, Bureau of Customs and Border Protection, 1300 Pennsylvania Ave. N.W., Washington, D.C. 20229.

Sincerely,

Robert B. Swierupski
Director,

Previous Ruling Next Ruling

See also: