United States International Trade Commision Rulings And Harmonized Tariff Schedule
faqs.org  Rulings By Number  Rulings By Category  Tariff Numbers
faqs.org > Rulings and Tariffs Home > Rulings By Number > 2003 NY Rulings > NY J86135 - NY J86179 > NY J86163

Previous Ruling Next Ruling
NY J86163




June 25, 2003

CLA-2-59:RR:NC:TA:350 J86163

CATEGORY: CLASSIFICATION

TARIFF NO.: 5903.20.2500

Mr. Gerwald Meilen
Aunde Corporation
3000 Town Center, Suite 1385
Southfield, MI 48075

RE: The tariff classification of knit textile fabrics laminated with foam, for automobile trim and seat upholstery, from Brazil.

Dear Mr. Meilen:

In your letter dated June 9, 2003, you requested a tariff classification ruling.

Two samples were submitted which were identified as “Windsor Warp-Knit.” In a recent telephone conversation with this office, you reiterated that the samples have the same construction, but can have a different surface finish. Further, since these are only representative samples, no specific style or quality numbers have been assigned to the individual samples. A control number would be given after and order is placed for customer tracking and shipping.

Specifically, the two samples consist of a layer of polyurethane plastics foam, which has been sandwiched between two warp knit fabrics. This foam layer is clearly visible in cross section. The face fabric is composed of 100% polyester man-made fibers while the backside is composed of 100% polyamide man-made fibers. The outer or top surfaces of both materials have different surface characteristics. One is brushed while the other, although knit, has the appearance of a dobby weave.

According to your correspondence, these materials will be imported in thicknesses ranging from 3 to 8mm and will weigh between 340 and 575 grams per square meter. The submitted samples were 5 and 4 mm thick, respectively. While it was not clear from your technical specification sheet, based on the submitted samples, the weight of the plastics portion vis a vis the textile, does not appear to be over 70 percent by weight of the total weight of the material. Specific data on a particular quality may result in a different textile to plastic weight ratio.

The applicable subheading for the two fabrics, which will be imported as roll goods up to approximately 50 yards in length and a width of approximately 59 inches or as cut rectangles for use as salesman samples, will be 5903.20.2500, Harmonized Tariff Schedule of the United States (HTS), which provides for textile fabrics impregnated, coated, covered or laminated, with plastics, with polyurethane, of man-made fibers, not over 70 percent by weight of rubber or plastics. The duty rate will be 7.6 percent ad valorem.

This ruling is being issued under the provisions of Part 177 of the Customs Regulations (19 C.F.R. 177).

A copy of the ruling or the control number indicated above should be provided with the entry documents filed at the time this merchandise is imported. If you have any questions regarding the ruling, contact National Import Specialist George Barth at 646-733-3044.

Sincerely,

Robert B. Swierupski
Director,

Previous Ruling Next Ruling

See also: