[ Home  |  FAQ-Related Q&As  |  General Q&As  |  Answered Questions ]


    Search the Q&A Archives


I replaced the thermostat, water pump in my '98 Dodge...

<< Back to: rec.autos.makers.chrysler FAQ, Part 1/6

Question by Richie
Submitted on 7/12/2004
Related FAQ: rec.autos.makers.chrysler FAQ, Part 1/6
Rating: Rate this question: Vote
I replaced the thermostat, water pump in my '98 Dodge caravan 3.3 because it was over heating.  It's still overheating the cooling fans aren't coming on.  What's happening?


Answer by d
Submitted on 8/11/2004
Rating: Not yet rated Rate this answer: Vote
Hopefully you've fixed it already, but if not go to Google and search for "caravan cooling fans" and you'll find several hits regarding similar problems. Most point to the cooling fan relay unit located to the left of the raditor. It's a small square dark colored box held down by 1-2 screws. It may be bad or it may not be bolted down tight enough. It needs to make a good connection to the frame to be grounded properly otherwise it won't work. You should also try to bypass the switch and wire the fans directly to the battery to verify that the fans work.

 

Answer by dude
Submitted on 12/31/2004
Rating: Not yet rated Rate this answer: Vote
fan relay switch

 

Answer by dee
Submitted on 6/18/2005
Rating: Not yet rated Rate this answer: Vote
Well it can be many things does it cool off as your driving?? if so its cuss the fans are not coming on check the relay and the sensor.Flush your rad, Check your oil and if it has a white foamy look to it head gasket

 

Answer by A little late
Submitted on 7/16/2005
Rating: Not yet rated Rate this answer: Vote
There's a fan control module behind the front bumper (left or right side I forget) that was bad on our '98 3.0L; check the fans themselves by hooking up 12v directly to see if they spin; if so go for the control module.

 

Answer by Katherine the amazing auto repairer
Submitted on 3/30/2006
Rating: Not yet rated Rate this answer: Vote
It's either your thermostat or your senser which should kick in once your engine has reached standard idle temperature. The next thing to do is to check and see if the fan is working at all and you can do this by jumping directly to your battery. At that point if the fan dose NOT kick on is IS your sensor.

 

Your answer will be published for anyone to see and rate.  Your answer will not be displayed immediately.  If you'd like to get expert points and benefit from positive ratings, please create a new account or login into an existing account below.


Your name or nickname:
If you'd like to create a new account or access your existing account, put in your password here:
Your answer:

FAQS.ORG reserves the right to edit your answer as to improve its clarity.  By submitting your answer you authorize FAQS.ORG to publish your answer on the WWW without any restrictions. You agree to hold harmless and indemnify FAQS.ORG against any claims, costs, or damages resulting from publishing your answer.

 

FAQS.ORG makes no guarantees as to the accuracy of the posts. Each post is the personal opinion of the poster. These posts are not intended to substitute for medical, tax, legal, investment, accounting, or other professional advice. FAQS.ORG does not endorse any opinion or any product or service mentioned mentioned in these posts.

 

<< Back to: rec.autos.makers.chrysler FAQ, Part 1/6


[ Home  |  FAQ-Related Q&As  |  General Q&As  |  Answered Questions ]

© 2008 FAQS.ORG. All rights reserved.