i have a 1995 dodge stratus and i am trying to get the...

<< Back to: rec.autos.makers.chrysler FAQ, Part 1/6

FAQS.ORG makes no guarantees as to the accuracy of the posts. Each post is the personal opinion of the poster. These posts are not intended to substitute for medical, tax, legal, investment, accounting, or other professional advice. FAQS.ORG does not endorse any opinion or any product or service mentioned mentioned in these posts.

<< Back to: rec.autos.makers.chrysler FAQ, Part 1/6

[ Home | FAQ-Related Q&As | General Q&As | Answered Questions ]

Question by cintomayor
Submitted on 2/25/2004
Related FAQ: rec.autos.makers.chrysler FAQ, Part 1/6
Rating:	Rate this question:
i have a 1995 dodge stratus and i am trying to get the harmonic ballance pulley off.i used a 3 jaw pulley remover but it will not break loose.i have beat on it but no movement.any sugesstions is greatly appriciated

Answer by oldwizard
Submitted on 4/7/2004
Rating:	Rate this answer:
you need a harmonic gear puller. up here in Canada we buy them from peavey Mart

Answer by RaceCarBob
Submitted on 12/26/2004
Rating: Not yet rated	Rate this answer:
The three jaw is correct on this three spoke balancer. (specificly the 4" three jaw puller). The trick is to put a bolt smaller then the hole in the balancer bolt hole that will stick out about 1" then press off of protruding bolt head. The balancer is hubbed on to the crank. Re-install with the original fastner.

Your name or nickname:
If you'd like to create a new account or access your existing account, put in your password here:
Your answer: