upvc door euro lock. I need to replace in locked position. ...

<< Back to: alt.locksmithing answers to Frequently Asked Questions (FAQ)

FAQS.ORG makes no guarantees as to the accuracy of the posts. Each post is the personal opinion of the poster. These posts are not intended to substitute for medical, tax, legal, investment, accounting, or other professional advice. FAQS.ORG does not endorse any opinion or any product or service mentioned mentioned in these posts.

<< Back to: alt.locksmithing answers to Frequently Asked Questions (FAQ)

[ Home | FAQ-Related Q&As | General Q&As | Answered Questions ]

Question by shoestyle
Submitted on 1/26/2004
Related FAQ: alt.locksmithing answers to Frequently Asked Questions (FAQ)
Rating:	Rate this question:
upvc door euro lock. I need to replace in locked position. This door and frame has not been fitted yet. I have removed the brass plate on the door and released the locking mecanism,but am unable to release lock.

Answer by marzie
Submitted on 2/26/2005
Rating: Not yet rated	Rate this answer:
drill just below the keyhole till you drillout five pins they should fall down allowing the cylinder to rotate.

Answer by leigh
Submitted on 4/22/2005
Rating: Not yet rated	Rate this answer:
make sure u have unsrewed the screw on the side of the lock then put the existing key in the lock and try turning the key slightly n pulling the lock at the same time this shud work.... oh u also dont need to remove the handles

Answer by mitch
Submitted on 7/17/2005
Rating: Not yet rated	Rate this answer:
how do i replace a cylinder lock in upvc front door

Answer by scubaman
Submitted on 4/4/2006
Rating: Not yet rated	Rate this answer:
you need to remove the screw on the upright jamb edge - there is a screw level with the bottom of the lock.

Your name or nickname:
If you'd like to create a new account or access your existing account, put in your password here:
Your answer: